1. Find the frame.
Locate the two upright sections and the sawhead between them.
A different
point of balance.
The question is simple: where is the cutting blade supported as the saw travels along a log?
Read Canadian patent 3,216,945A 10-second explanation
See the arrangement take shape.
This animation shows the idea in the patent. It is a simplified diagram, not footage of a cut or a measured comparison.
The idea in plain languagePut the cutting
Put the cutting
assembly nearer
the centre.
On the arrangement described in Canadian patent 3,216,945, the powerhead and band saw blade sit between two upright frame sections. The patent describes the cutting assembly near the carriage’s point of balance, with support on both sides as the mill moves along its rails.
Think of Gord’s road grader comparison: the position of the working part relative to its supporting frame matters. Here, the aim is to limit movement at the blade during a cut. The patent describes that intended benefit; an actual cut also depends on the blade, timber, setup and operator.
This is an explanation of the patent disclosure, not a measured comparison with another manufacturer or a guarantee of cut quality. Confirm the current Little Ripper configuration with Gord.
See the idea
doing the work.
2. Watch the blade.
See a real cut and ask about blade choice, log condition and setup.
3. Inspect the board.
Look at the resulting surface yourself and discuss what a comparable test would involve.
Source video shows equipment in use; the on-site demonstration can be tailored to the questions you bring.
Start with your projectLet’s find the right
Let’s find the right
equipment for your place.
Tell Gord about your property, your logs and what you want to make.
Have a conversation